Procom MU 4-zg-... - Manual (Page 2)

INSTALLATION
The antenna whip comprises a ¼ λ section, a phase shifting coil, and a ½ λ
section. The ZG-mount is designed for mounting from the outside in a 21
mm dia. hole on horizontal surfaces as e.g. roof top or trunk lid.
The mount is provided with an M8 x 1 thread mount system. This
construction meets the demand for a low-profile mobile mount with a slim
appearance and with protection against theft of the antenna whip.
When cleaning the car in car-washing machines, the whip is easily removed
using a spanner, size 12 mm. The whip is refitted again by screwing it onto
the thread stud and tightening it with the spanner.
The MZG-mount antennas are provided with a large-diameter, thoroughly
magnetized permanent ring magnet with an extraordinarily high attaching
effect. A silicone layer applied to the whole contact surface protects the car
roof and ensures maximum friction.
Please note that whips from the ZG/ZGP4 mounts and the whips from the
MZG-mount are not compatible.
1. INSTALLATION DIMENSIONS
2. INSTALLATION STEPS
Do not use sealer on rubber gasket or other places.
3. TUNING
PLEASE NOTE
For safety reasons:
When using the MU 4-MZG/…, car speed must not exceed 140 km/h.
PROCOM A/S reserve the right to amend specifications
without prior notice.
15/12/11