Procom PRO-DIPX 88-136-n - Manual

PRO-DIPX 88/136-N
Diplexer for the 0 - 88 MHz and 136 - 1300 MHz Ranges
DESCRIPTION
Diplexer for combining or splitting the two ranges 0 - 88 MHz and 136 -
1300 MHz.
Excellent wide-band coverage – usable for a lot of applications.
N-connections on all terminals.
ORDERING DESIGNATIONS
TYPE PRODUCT NO.
PRO-DIPX 88/136-N 200000681
SPECIFICATIONS
ELECTRICAL
MODEL PRO-DIPX 88/136-N
FREQUENCY Low port : 0 - 88 MHz
High port : 136 - 1300 MHz
MAX. INPUT POWER 35 W each port
INSERTION LOSS 0 - 88 MHz : ≤ 0.7 dB
136 - 1300 MHz : ≤ 0.7 dB
ISOLATION Low to high port: ≥ 40 dB
IMPEDANCE 50 Ω on all terminals
MECHANICAL
TEMP. RANGE –30° C → +70° C
CONNECTORS Low : N
High : N
Antenna: N
DIMENSIONS (W x H x D) 138 (incl. connectors) x
152 (incl. flanges) x 35 mm /
5.43 (incl. connectors) x
5.98 (incl. flanges) x 1.38 in.
WEIGHT Approx. 325 g / 0.72 lb.
TYPICAL RESPONSE CURVES
The PRO-DIPX 88/136-N makes it possible to use only one antenna for the
operation of two transceivers (one in each range). See the figure below. The
antenna must be a dual-frequency antenna, that is, it must be resonant on
the actual frequencies in the two bands. The transceivers may be used
independently and will have no degrading influence on each other. Typically,
the diplexer is installed next to the transceivers and only one cable is used
between the diplexer and the antenna. The diplexer is suitable both for base
station and mobile use.
The main tasks of the diplexer are to protect the individual receiver input
from being destroyed by the transceiver in the contrary band and to ensure
a low-loss path between the transceiver and the antenna which is not
loaded by the other branch.
The diplexer can be operated together with any set of transceivers operating
within the 0 - 88 MHz and 136 - 1300 MHz frequency bands.
Dual-frequency antennas are available for both mobile and base station
applications.
PROCOM A/S reserve the right to amend specifications
without prior notice.
03/03/14