SCANTECH ID (Champtek company) SG20 - Manual (Page 5)

Interface Manual Scantech SG-20 Discovery WLAN Rel 1.1 3
Introduction:
How to Connect to and Configure the SG-20 Discovery WLAN
Before the WLAN interface will work, some 802.11b/g specific parameters (like SSID, WEP keys,
etc) have to be configured first.
Since it's not likely that the wireless communication will work without these specific parameters,
the Discovery has to be configured to work with wired 10/100 Base-T Ethernet first. This way the
802.11b/g settings can be made while interfacing on the 10/100 Base-T Ethernet. (Don't forget
to plug a network cable into the backside of the Discovery also...)
Below you find a detailed description how set-up the Discovery WLAN. In fact there are 6 phases:
PHASE STEPS
1. If no wireless connection has been made before, the initial 802.11b/g settings
have to be configured first. This requires the unit to interface through 10/100
Base-T wired Ethernet, in order to get access to the proper configuration menu.
1 - 1.14
2. Make connection between your host or Back-Office computer and the
SG-20/WLAN terminal, using UStart.exe (or any other telnet program, see
also chapter 7) to enter the configuration menu through a Telnet session.
2 - 2.6
3. Configure the WLAN 802.11b/g settings. 3 - 3.10
4. Configure the IP-settings of the SG-20/WLAN. 4 - 4.5
5. Set the Back-Office/Server IP-settings in the SG-20/WLAN. 5 - 5.14
6. Save and exit. 6