SCANTECH ID (Champtek company) LIBRA L-7080i - Manual (Page 4)

Copyright
©
2012, Scantech-ID BV
This manual is copyrighted, with all rights reserved. Under the copyright laws, this manual may not, in whole or in
part, be copied, photocopied, reproduced, translated or converted to any electronic medium or machine readable
form without prior written consent of Scantech-ID.
Limited Warranty
Under all circumstances this manual should be read attentively, before installing and/or using the product. In no
event shall Scantech-ID be liable for any direct, indirect, special, consequential or incidental damages arising out of
the use or inability to use this documentation or product, even if advised of the possibility of such damages. In
particular, Scantech-ID shall not be liable for any hardware, software, or data that is stored or used with the
product, including the cost of repairing, replacing or recovering the above. Scantech-ID reserves the right to change
parts of the device at any time without preceding or direct announcement to the client.
Scantech-ID reserves the right to revise this manual, and to make changes in the contents without obligation to
notify any person or entity of the revision or change. A serial number appears on the product. Make sure that this
official registration number has not been removed. It should be used whenever servicing by Scantech-ID or an
authorized Scantech dealer is necessary.
Important
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
EN55022, and with the limits for a class A digital device, pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the user’s manual, may cause harmful interference to radio communications.
Operation of the equipment in a residential area is likely to cause harmful interference in which case the user will
be required to correct the interference at his own expense. Any unauthorized changes or modifications to this
equipment could void the user’s authority to operate this equipment.
For CE-countries:
– LIBRA is in conformity with the CE standards. Please note that a Scantech CE-marked power supply unit should
be used to conform to these standards.
P/N: 0145-SIL0051 V3.0 Oct. 2013