SCANTECH ID (Champtek company) V-1010BT - Manual (Page 16)

8
ATTENTION
The V-1010BT scanner must be charged for a
minimum of 8 hours before the scanner can be
placed in full operation for the first time.
The scanner LED will indicate in red when the
scanner is charged.
After the battery is full, the green LED on
scanner will be on. The charge green LED will
be off when the scanner leaving from cradle.
If the battery power of the V-1010BT is too
low, the V-1010BT will indicate red LED and
beeper warning.
It is important to know that the V-1010BT scanner will
only communicate with the cradle whose unique Bluetooth
MAC address was last scanned.
If a cradle is paired with the V-1010BT scanner, another
V-1010BT scanner can’t be paired with that cradle until
the original connection is interrupted.
If you pair a second V-1010BT scanner to an in-use cradle,
the cradle’s connection to the first V-1010BT scanner
will be interrupted and the connection will be re-
established with the second V-1010BT scanner.
Bluetooth MAC
Address