SCANTECH ID (Champtek company) SG300RFM - Manual (Page 10)

7
USB
1. Turn off the host device.
2. Connect the 10-pin RJ45 male connector into the 10-pin
modular jack on the bottom of the charger cradle.
3. Connect the USB A type connector to the USB port on the
host device.
4. Plug the power supply into the power jack on the bottom of
the cradle.
5. Plug the power supply into the AC outlet. The red LED on the
rear of the cradle will stay on.
6. Turn on the host device.
7. Establish communication between the scanner and cradle.