SCANTECH ID (Champtek company) Discovery SG-20 - Manual (Page 33)

Scantech-ID Discovery SG-20 25
Next to the Classic version shown above, there is another version, the
Separator Box Version 2.
For your ease this version is fully backward compatible with the classic version.
However it has some additional connecting options for the power supply and
the serial cable to the host and moreover it has a higher maximal
communication speed. So Version 2 can act as a full replacement for the
Classic Version.
Power :
(use either
2.0mm (left) or
1.3mm (right))
Center = ground.
Host : Female port for 6-pin shielded
AMP5-555175-2 connector from
back office system (RS-232)
(Alternative for 9p Sub D-conn on other side of box)
ScanGuide : Female port for 8-pins
AMP 554169-1 connector
towards Discovery(s)
LEDs :
Green: RS-232 RX-data
(from Host to SG-20)
Red: Power On
Green: RS-232 TX-data
(from SG-20 to Host)
Host : 9-pin Sub-D Female port for
1-1 cable from back office system
(RS-232)
Separator Box Version 2
Install the separator box as follows:
1. Plug the cable coming from the Discovery into the “ScanGuide” port of the
separator box.