QTech Data Systems WP2P Repeater Module - Manual (Page 3)

WP2P – Repeater Module - Quick Start Guide – v1.2 – June 2013 3
www.qtech.co.nz Tel: 03 3663713
Aerial Selection Notes
The aerial selected for the Repeater will most likely be an “omni
directional” whip type aerial.
We recommend part number PD9218 as a suitable aerial for the
repeater. This is an external mounting, professional grade aerial
with 5m of coax and a stainless mounting bracket.
Each Repeater module is supplied with the standard stub aerial
which is perfect for system testing and short range applications.
The use of directional Yagi type aerials is unlikely to be a suitable
solution for a Repeater.
Power Supply Notes
Power Supply & Current Consumption
The WP2P Repeater operates from a nominal 12 Volt DC power supply.
Current consumption is ~30mA.
The power connector is a 2.1mm DC Socket, centre pin positive. The supply voltage should
be clean, continuous and transient free with an output of 12 Volts +/- 1.5 Volt DC. The WP2P
incorporates reverse and overvoltage protection.
The absolute maximum supply voltage is 13.8 V DC and any solar/battery design needs to
take this into account.
Warning – Do NOT use Switch Mode Power Supplies (SMPS) with this product. The
DC power supply used for this product MUST have a grounded negative or be a
“linear” transformer based plug pack. The reason is that the aerial, programming port
and external connections can provide exposed earth points and the SMPS can impose
an AC voltage on the DC ground, which can lead to damage. Suitable cost effective
plug packs are available from QTech P/N PD5412, PD5413 & PD5414.
Internal Fuse
The WP2P module circuit is protected by a 20mm x 5mm 500mA fast blow fuse. This is
located on the internal circuit board. To access the fuse, remove the top cover by prizing it off
its retaining dimples. Only replace the fuse with an identical type, do not use alternatives.
This fuse will blow if the power supply maximum voltage is exceeded.
Over Voltage Protection
The WP2P module is over voltage protected by a 13 volt Zener Diode ‘crow bar’ that will
conduct and blow the internal fuse for voltages >14 volts. The WP2P will tolerate 13.8 volts,
but will begin to draw excessive current and blow the fuse at input voltages >14.6V.
Note – Solar Supplies and design considerations
Before using any WP2P module in a solar powered system please check our “Solar
Application Note” on our website. Explicit consideration must be given to the
maximum voltage and voltage regulation to prevent damage.