Dayton Audio HDN-8 Weatherproof Sound Exciter Transducer - Manual

New Construction
When installing the HDN-8 into new construction, use a 10 inch square piece of hardwood ¼" to ½" thick and suspend it from the adjacent studs as shown
using woven Nylon or flexible plastic straps attached using drywall screws. Install the HDN-8 into the rear of the hardwood panel. When drywall is installed, in-
stall four drywall screws thru the drywall into the hardwood panel. This creates a high quality ‘hidden speaker’ within the wall itself. A low frequency panel may
be created by using a larger or thicker piece of hardwood and multiple HDN-8 transducers with electrical low-pass filtering. Hardwood provides the best audio
quality, but plywood may also be used; be sure to use consistent thicknesses and sizes of wooden material for all ‘hidden speakers’ to ensure matched output.
daytonaudio.com
Designed and Engineered in USA
Existing Construction
The HDN-8 is also easy to retrofit into an existing space. Install the HDN-8 into a 5-inch by 10-inch rectangular piece of hardwood or plywood. Cut a 5" x 5"
hole in the drywall below the location where the ‘hidden speaker’ will be installed, and pull the speaker cable through the hole to attach to the transducer as
prescribed. Apply a construction adhesive to the side of the panel opposite where the HDN-8 transducer is installed, and insert it into the wall void. Hold the
panel in a vertical orientation at the desired height and install two drywall screws through the drywall and into the panel, in order to hold the panel in place
while the adhesive cures.
Other Applications
The HDN-8 is extremely versatile, and can be used in any application where sound is required, but exposed or visible speakers are undesirable. This
includes multimedia exhibits, electronic casino gaming equipment, and arcade games. Additionally, the HDN-8 can add sound to furnishings, bathroom
fixtures, cabinets, and under flooring. When using the HDN-8 in these applications, observe all precautions outlined in the User Manual. It is recommended
that the HDN-8 be installed into a wooden structural component coupled to the surface, or into a wooden plate bonded to the surface that will produce
sound. When multiple HDN-8 transducers are used, series-parallel wiring may be employed to ensure the proper impedance load for the amplifier.
© Dayton Audio ® Last Revised: 3/7/2013
Under Flooring
Under Decking
Speaker
Wire
Straps
Alignment
Marks
Drywall
Drywall Screws
Alignment
Marks
If at any time you feel uncomfortable with
the installation or use of this product
please consult a professional installer. When mounting, tighten only to a snug
fit. Overtightening may result in damage
to your transducer.
Below are some recommended applications for the versatile
Dayton Audio HDN-8 transducer.
NOTE!
Hidden Weatherproof Full Range Sound
Exciter Transducer Applications Guide
Model: HDN-8