Dayton Audio RS722 Speaker Kit w - Manual

Frequency Graph
Specifications: • Impedance: 4 ohms • Frequency response: 41-20,000 Hz • SPL: 87.5 dB 2.83V/1m • Power handling: 100 watts RMS.
The Dayton RS180S-8 woofers and Dayton RS28AS-4 tweeter have been sonically matched and integrated in this system. Both drivers’ motors
incorporate magnetic shielding to prevent interference with adjacent equipment. The net crossover point between the woofer and tweeter is at
about 1,650 Hz and its steep slope helps protect the tweeter from over-excursion. The tweeter utilizes a relatively standard fourth-order electrical
filter, while the woofer uses a third-order electrical filter with a conjugate network to achieve its fourth-order rolloff.
The overall frequency response is quite flat although a somewhat exaggerated BBC dip was built into the on-axis response to improve off-axis
performance. This system excels in both imaging ability and dynamic range. The speakers easily “disappear” in the room as they precisely recre-
ate everything from extremely quiet passages to full-orchestra crescendos.
Loudspeaker Kit
Components
Based on the
Dayton Audio RS722 Speaker Kit
The crossovers included with this kit were optimized for the above driver/cabinet combination. A diagram of the optimal cabinet has been provided as a
guideline. Varying greatly from the optimal cabinet volume may result in changes to the frequency response and less than desired performance.
Crossover Diagram Optimal Cabinet (1.0 ft 3 )