Asus P5Q SE2 - Manual (Page 20)

1-10 Chapter 1: Product introduction
1.6.2. Installing.the.CPU.heatsink.and.fan
The Intel ® LGA775 processors require a specially designed heatsink and fan assembly to
ensure optimum thermal condition and performance.
• When you buy a boxed Intel ® processor, the package includes the CPU fan and
heatsink assembly. If you buy a CPU separately, ensure that you use only Intel ® -certified
multi-directional heatsink and fan.
• Ensure that you have installed the motherboard to the chassis before you install the
CPU fan and heatsink assembly.
• If you purchased a separate CPU heatsink and fan assembly, make sure that you have
properly applied Thermal Interface Material to the CPU heatsink or CPU before you
install the heatsink and fan assembly.
Your Intel ® LGA775 heatsink and fan assembly comes in a push-pin design and requires no
tool to install.
The type of CPU heatsink and fan assembly may differ, but the installation steps and
fucntions should remain the same. The illustration above is for reference only.
To install the CPU heatsink and fan:
1.
Place the heatsink on top of the installed CPU,
ensuring that the four fasteners match the holes
on the motherboard.
2. Push down two fasteners at a time in a
diagonal sequence to secure the heatsink and
fan assembly in place.
A
A
B
B
1
1
A B
B A
3. Connect the CPU fan cable to the connector on the motherboard labeled CPU_FAN.
Do not forget to connect
the CPU fan connector!
Hardware monitoring errors
can occur if you fail to plug
this connector.
CPU_FAN
GND
CPU FAN PWR
CPU FAN IN
CPU FAN PWM
P5Q SE2
P5Q SE2 CPU fan connector