Asus P5Q-E/WiFi-AP - Manual (Page 159)

ASUS P5Q-E 4-49
Using Drive Xpert funcition in BIOS setup environment
You may use Drive Xpert function in BIOS setup environment. Enter BIOS setup
by presssing DEL key after powering on. Go to Advanced menu, select Onboard
Device Configuration, then press <Enter>.
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
v02.61 (C)Copyright 1985-2008, American Megatrends, Inc.
Onboard Device Configuration
High Definition Audio [Enabled]
Front Panel Type [HD Audio]
Marvell IDE [Enabled]
PCIE IDE Boot ROM [Enabled]
Marvell LAN1 [Enabled]
LAN Boot ROM [Disabled]
Marvell LAN2 [Enabled]
LAN Boot ROM [Disabled]
Agere Firewire 1394 [Enabled]
Drive Xpert Mode Update [Mode change]
Update to Super Speed [Press Enter]
Update to EZ Backup [Press Enter]
Update to Normal Mode [Press Enter]
Serial Port1 Address [3F8/IRQ4]
Enable or Disable
High Definition Audio
Controller
BIOS SETUP UTILITY
Advanced
Drive Xpert Mode Update [Current setting]
Set this item to [Mode change] to show further settings of the Drive Xpert Mode change] to show further settings of the Drive Xpert ] to show further settings of the Drive Xpert
function. Configuration options: [Current setting] [Mode change]
Update To Super Speed [Press Enter]
This item appears only when the Drive Xpert Mode Update item is set to [Mode
change] and allows you to use Super Speed function. Plug two identical SATA hard
drives in the SATA_E1 (orange, port 0) and SATA_E2 (white, port 1) connectors on SATA_E2 (white, port 1) connectors on
the motherboard and press the <Enter> key. and press the <Enter> key.
Update To EZ Backup [Press Enter]
This item appears only when the when the Drive Xpert Mode Update item is set to [Mode
change] and allows you to use and allows you to use allows you to use EZ Backup function. Plug two identical SATA hard . Plug two identical SATA hard
drives in the SATA_E1 (orange, port 0) and SATA_E2 (white, port 1) connectors on SATA_E1 (orange, port 0) and SATA_E2 (white, port 1) connectors on connectors on connectors on
the motherboard and press the <Enter> key. and press the <Enter> key.
Make necessary backup before using the Drive Xpert function:
• All original data of the hard drive connected to the SATA_E2 (white, port 1)
connector on the motherboard will be erased for EZ Backup setup
• All original data of the two hard drives will be erased for Super Speed
setup.
Update To Normal Mode [Press Enter]
This item appears only when the when the Drive Xpert Mode Update item is set to [Mode
change] and allows you to use the SATA_E1 (orange, port 0) and SATA_E2 (white, and allows you to use the SATA_E1 (orange, port 0) and SATA_E2 (white, the SATA_E1 (orange, port 0) and SATA_E2 (white,
port 1) connectors as normal SATA connectors. as normal SATA connectors.