Asus M2N68-AM SE - Manual (Page 30)

2. Open Network.
3. Make the proper network configurations.
Each network interface is enabled immediately after you tick the Enable checkbox.
Network
• If you use a network cable connected to a home router that is connected to your DSL/
cable modem, enable all the LAN ports. Express Gate automatically uses the available
port.
• If your computer does not automatically get network settings from a DHCP server, click
Setup to configure the static IP settings manually. If your computer automatically gets
network settings from a DHCP server, skip this step.
• The number of the LAN ports vary with the motherboard.
• If you plug the network cable into a different port while Express Gate is running (e.g.
move the cable from LAN1 to LAN2), press the Refresh button to activate the new
setting.
Chapter 1: Product introduction 1-21