Asus P5B-VM SE - Manual (Page 64)

2-16 Chapter 2: BIOS setup
PIO Mode [Auto]
Selects the PIO mode.
Configuration options: [Auto] [0] [1] [2] [3] [4]
DMA Mode [Auto]
Selects the DMA mode. Configuration options: [Auto]
SMART Monitoring [Auto]
Sets the Smart Monitoring, Analysis, and Reporting Technology. Configuration
options: [Auto] [Disabled] [Enabled]
32Bit Data Transfer [Enabled]
Enables or disables 32-bit data transfer.
Configuration options: [Disabled] [Enabled]
2.3.5 IDE Configuration
The items in this menu allow you to set or change the configurations for the IDE
devices installed in the system. Select an item then press <Enter> if you wish to
configure the item.
IDE Configuration
SATA#1 Configuration [Enabled]
SATA#2 Configuration [Enabled]
Hard Disk Write Protect [Disabled]
IDE Detect Time Out (Sec) [35]
JMB368 Controller [Enabled]
SATA#1 Configuration [Enabled]
Allows you to enable or disable the SATA#1 Configuration. Configuration options:
[Disabled] [Enabled]
SATA#2 Configuration [Enabled]
Allows you to enable or disable the SATA#2 Configuration. Configuration options:
[Disabled] [Enabled]
Hard Disk Write Protect [Disabled]
Allows you to enable or disable the hard disk write protection. This will be effective
only if device is accessed through BIOS. Configuration options: [Disabled]
[Enabled]
IDE Detect Time Out [35]
Selects the time out value for detecting ATA/ATAPI devices.
Configuration options: [0] [5] [10] [15] [20] [25] [30] [35]