Chapter 2 – Asus Rampage IV Extreme User Manual
Page 57
ROG RAMPAGE IV EXTREME
2-33
Chapter 2
3.
ASMedia
®
Serial ATA 6.0 Gb/s connectors (7-pin SATA6G_E1/E2 [red])
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0
Gb/s signal cables.
•
The SATA6G_E1/E2 (red) connectors are for data drives only. ATAPI device is not
supported.
• You must install Windows
®
XP Service Pack 3 or later versions before using Serial ATA
hard disk drives.
• When using NCQ, set the
Asmedia Storage Controller item in the BIOS to [Enabled].
Refer to section
3.5.5 Onboard Devices Configuration for details.
4.
Subzero Sense connector
The Subzero Sense connector allows you to connect the K probe cable (purchased
seperately) to measure the motherboard temperature via BIOS, OC Key or
TurboV EVO without purchasing expensive multimeters.
Subzero Sense detects the connector’s ambient temperature when it’s plugged.