Braun 5780 Silk-épil 5 - Manual (Page 14)

14
Then press the release button (5) to
remove the epilation head (2).
Thoroughly shake both, the epilation
head and the appliance to make sure
that remaining water can drip out.
Leave both parts to dry. Before reat-
taching, make sure that they are com-
pletely dry.
B Using the shaver head
attachment
a Trimmer cap
b Shaver foil
c Trimmer
d Release buttons
e Trim/shave selector
f Cutter block
g Shaver head base
Shaving
• Remove the epilation head and put on
the shaver head attachment (9) by
clicking it in.
• Turn the switch clockwise to setting
«II».
• Make sure the trim/shave selector (e)
is in the « » position.
• For best results, always make sure
that both, the shaver foil (b) and the
trimmer (c) are in contact with the skin
(A). Keeping your skin stretched (B),
slowly move the appliance against the
direction of hair growth. The trimmer
first raises all long hairs and cuts them
off. Then the flexible foil follows to
smooth away any stubble.
• When shaving or trimming in sensitive
areas, make sure that you always keep
your skin stretched to avoid injuries.
Contour trimming
For trimming precise line and contours,
lock the long hair trimmer by sliding the
trim/shave selector (e) to the position
« » (C1).
Pre-cutting hair for epilation
If you choose to pre-cut your hair to
the ideal length for epilation, place the
trimmer cap (a) onto the shaver head.
Slide the trim/shave selector (e) to the
« » position.
Hold the appliance with the trimmer cap
lying flat on the skin. Guide it with the
comb tips against the hair growth as
shown in illustration (C2).
Since hairs usually grow in various
directions, guide the appliance slightly
diagonally or in different directions in
order to achieve best results.
Cleaning the shaver head
After each use, unplug the appliance.
Brush cleaning
• Press the release buttons (d) to
remove the shaver head (D1). Tap the
bottom of the shaver head gently on a
flat surface (not on the foil).
• Brush out the cutter block and the
inside of the shaver head. However, do
not clean the shaver foil with the brush
as this may damage the foil.
Cleaning with water
Press the release buttons (d) to remove
the shaver head. Rinse the shaver head
and the cutter block separately under
running water (D2). Leave the cutter
block and the foil frame to dry separately
before reattaching them.
Keeping your shaver head
attachment in top shape
• The shaving parts need to be lubricated
regularly every 3 months (E). If you
clean the shaver head under running
water, please lubricate it after every
cleaning.
• Apply some light machine oil or vaseline
to the shaver foil and the metal parts
of the long hair trimmer. Then remove
the shaver head and also apply a tiny
amount of vaseline as shown in picture
section (E).
92191011_SE5780_MN_S6-88.indd 14 20.01.12 09:02