Asus P4P800 - Manual (Page 137)

ASUS P4P800 motherboard user guide 5-23
2. Select the stripe value for the RAID 0 array by scrolling through the
available values by using the Up and Down arrow keys and
pressing the <Enter> key.
3. The available values range from 8 KB to 128 KB increments. The
strip value should be chosen based on the planned drive usage.
Some suggested selections are listed below. The default selection
is 64 KB.
• 16 KB - low disk usage
• 64 KB - typical disk usage
• 128 KB - performance disk usage
4. Press the <Enter> key again to the Create Volume prompt to create
the array. Confirm this selection by pressing the <Y> key after the
prompt.
Are you sure you want to create this volume (Y/N)
5. Scroll to option 4 Exit and press the <Enter> key to exit the RAID
configuration utility. Confirm the exit by pressing <Y> key.
5.4.5 Deleting a RAID Volume
[ HELP ]
Deleting a volume will destroy the volume data on the drive(s) and
cause any member disks to become available as non-RAID disks.
WARNING: EXISTING DATA WITHING THIS VOLUME WILL BE LOST AND NON-RECOVERABLE
Intel(R) Integrated RAID for Serial ATA - RAID Configuration Utility
Copyright(C) 2003 Intel Corporation. All Rights Reserved. v3.x.x.xxxx
[ DELETE ARRAY MENU ]
[ ]-Change [ ]-Change [TAB]-Next [TAB]-Next [<ESC>]-Previous Menu [<ESC>]-Previous Menu [<DEL>]-Delete Volume [<DEL>]-Delete Volume
Name Level Drives Capacity Status Bootable
RAID_Volume1 RAID0(Stripe) 2 37.2GB Normal Yes
Take caution in using this option; All data on the RAID drives will be
lost!