Asus CS-B - Manual (Page 19)

ASUS CS-B 1-11
• If the steps above do not help, remove the onboard battery and move the jumper
again to clear the CMOS RTC RAM data. After clearing the CMOS, reinstall the
battery.
• You do not need to clear the RTC when the system hangs due to overclocking. For
system failure due to overclocking, use the CPU Parameter Recall (C.P.R.) feature.
Shut down and reboot the system, then the BIOS automatically resets parameter
settings to default values.
1.7 Connectors
1.7.1 Rear panel connectors
2. Intel ® ME jumper (3-pin DIS_ME)
This jumper allows you to enable or disable the Intel ® ME function. Set this jumper to
pins 1-2 to enable (default) the Intel ® ME function and to pins 2-3 to disable it.
Disable the Intel ® ME function before updating it.
2 2 3
Normal
(Default)
Disable ME
DIS_ME
1
CS-B Intel ® ME jumper
CS-B
6 7
8
1
12 10 9
4
9 11
2 3 5
1. PS/2 mouse port (green). This port is for a PS/2 mouse.
2. DVI-D port. This port is for any DVI-D compatible device. DVI-D can’t be converted to
output RGB Signal to CRT and is not compatible with DVI-I.
3. DisplayPort. This port is for DisplayPort-compatible devices.