Asus P5A-B - Manual (Page 45)

ASUS P5A-B User’s Manual 45
C8000 - CBFFF Shadow to DC000 - DFFFF Shadow (Disabled)
These fields are used for shadowing other expansion card ROMs. If you install other
expansion cards with ROMs on them, you will need to know which addresses the
ROMs use to shadow them specifically. Shadowing a ROM reduces the memory
available between 640KB and 1024KB by the amount used for this purpose.
Boot Up NumLock Status (On)
This field enables users to activate the Number Lock function upon system boot.
Typematic Rate Setting (Disabled)
When enabled, you can set the Typematic Rate and Delay.
Typematic Rate (Chars/Sec) (6)
This field controls the speed at which the system registers repeated keystrokes. Op-
tions range from 6 to 30 characters per second. Setup default setting is 6; other
settings are 8, 10, 12, 15, 20, 24, and 30.
Typematic Delay (Msec) (250)
This field sets the time interval for displaying the first and second characters. Four
delay rate options are available: 250, 500, 750, and 1000.
Security Option (System)
When you specify a Supervisor Password and/or User Password (explained later in
this section), Security Option determines when the system prompts for the pass-
word. The default setting is System, where the system prompts for the User Pass-
word every time you start your system. The other option is Setup, where the system
goes through its startup routine unless the Setup utility is called, when the system
prompts for the Supervisor Password.
IV. BIOS SOFTWARE
IV
. BIOS
BIOS/Chipset Features
Chipset Features Setup
Chipset Features Setup controls the configuration of the board’s chipset. Control
keys for this screen are the same as in the BIOS Features Setup screen.
NOTE: SETUP defaults are enclosed in parentheses next to each function heading.