Asus Terminator A7VT - Manual (Page 35)

ASUS Terminator 1 A7VT barebone system 35
2.11 Re-connecting cables
You may have disconnected some cables when you were installing
components. You must re-connect these cables before you replace the
chassis cover.
2.11.1 LED cables
•
Connect the power switch and power LED cables to their respective
leads in the PANEL connector on the motherboard.
•
Connect the HDD LED cable to the 2-pin lead marked HDLED.
Power Switch
Power LED
HDD LED
PANEL
* Requires an ATX power supply.
PLED
Ground
NC
PWR
+5VSB +5V Speaker
SPEAKER PLED
Ground
HDLED
RESET
SMI
HDLED
ExtSMI#
Ground
Reset
Ground Ground
PWRBTN*
+5 V