Asus A3Vp - Manual (Page 44)

44
4
Using the Notebook PC
Flash Memory Card Reader
Normally a PCMCIA memory card reader must be purchased separately in order to use memory cards
from devices such as digital cameras, MP3 players, mobile phones, and PDAs. This Notebook PC has
a single built-in memory card reader that can read the following flash memory cards: Secure Digital
(SD), Multi-Media Card (MMC), Memory Stick (MS), Memory Stick Select (MS Select), and Memory
Stick Pro. Memory Sticks may be standard or with MagicGate technology. The built-in memory card
reader is not only convenient, but also faster than most other forms of memory card readers because it
utilizes the high-bandwidth PCI bus.
MS (Memory Stick)
Select
MS (Memory Stick)
Magic Gate (MG)
MS (Memory Stick)
MMC (Multimedia Card)
SD (Secure Digital)
Supported Memory Types
IMPORTANT! Never remove cards while or immediately after reading, copying, for-
matting, or deleting data on the card or else data loss may occur.
SD / MMC
MS / MS Pro
Hard Disk Drive
Hard disk drives have higher capacities and operate at much faster speeds
than floppy disk drives and optical drives. The Notebook PC comes with
a replaceable 2.5” (6.35cm) wide and approximately .374” (.95cm) high
hard disk drive. Current hard drives support S.M.A.R.T. (Self Monitoring
and Reporting Technology) to detect hard disk errors or failures before
they happen. Most Notebook PC models use PATA (Parallel ATA) hard
drives, but selected models use SATA (Serial ATA) hard drives. When replacing or upgrading the hard
drive, always visit an authorized service center or retailer for this Notebook PC.
IMPORTANT! Poor handling of the Notebook PC may damage the hard disk drive.
Handle the Notebook PC gently and keep it away from static electricity and strong
vibrations or impact. The hard disk drive is the most delicate component and will
likely be the first or only component that is damaged if the Notebook PC is dropped.