Asus SABERTOOTH 990FX R2.0 - Manual (Page 91)

ASUS SABERTOOTH 990FX R2.0 3-21
Chapter 3
3.5.4 SATA Configuration
While entering Setup, the BIOS automatically detects the presence of SATA devices. The
SATA Port items show Not Present if no SATA device is installed to the corresponding SATA
port.
SB SATA Configuration
This item alows you to set the SATA configuration.
OnChip SATA Channel [Enabled]
Allows you to enable or disable the Serial ATA channel.
Configuration options: [Enabled] [Disabled]
The following items appear only when you set the OnChip SATA Channel to [Enabled].
SATA Port1 - Port 4 [AHCI]
Allows you to set the SATA configuration.
[IDE]
Set to [IDE] when you want to use the Serial ATA hard disk
drives as Parallel ATA physical storage devices.
[RAID] Set to [RAID] when you want to create a RAID configuration
from the SATA hard disk drives.
[AHCI] Set to [AHCI] when you want the SATA hard disk drives to
use the AHCI (Advabced Host Controller Interface). The AHCI
allows the onboard storage driver to enable advanced Serial
ATA features that increases storage performance on random
workloads by allowing the drive to internally optimize the order
of commands.
SATA Port 5 - Port 6 [AHCI]
Allows you to set the SATA configuration.
[IDE]
Set to [IDE] when you want to use the Serial ATA hard disk
drives as Parallel ATA physical storage devices.
[AHCI] Set to [AHCI] when you want the SATA hard disk drives to
use the AHCI (Advabced Host Controller Interface). The AHCI
allows the onboard storage driver to enable advanced Serial
ATA features that increases storage performance on random
workloads by allowing the drive to internally optimize the order
of commands.
Main Ai Tweaker Advanced Monitor Boot Tool
Exit
(1) IDE Mode. (2) AHCI Mode. (3)
RAID Mode.
Back Advanced\ SATA Configuration >
UEFI BIOS Utility - Advanced Mode
SATA Configuration
SATA 6G_1 Not Present
SATA 6G_2 Not Present
SATA 6G_3 Not Present
SATA 6G_4 Not Present
SATA 6G_5 Not Present
SATA 6G_6 Not Present
> SB SATA Configuration