Asus M2N-VM SE - Manual (Page 81)

ASUS M2N-VM SE 2-33
2.5.4. Hardware.Monitor
The items in this sub-menu displays the hardware monitor values automatically
detected by the BIOS. It also allows you to change CPU Q-Fan feature-related
parameters. Select an item then press <Enter> to display the configuration options.
Q-Fan.Controller.[Disabled]
Allows you to enable or disable the Q-Fan controller.
Configuration options: [Disabled] [Enabled]
CPU.Target.Temperature,.System.Target.Temperature
Allows you to set the CPU and system target temperature. Key in to input the
value, then press <Enter>.
CPU Temperature, System Temperature
The onboard hardware monitor automatically detects and displays the motherboard
and CPU temperatures. These items are not user-configurable.
CPU.Fan.Speed.[xxxxRPM].
Chassis.Fan.Speed.[xxxxRPM].
Power.Fan.Speed.[xxxxRPM]
The onboard hardware monitor automatically detects and displays the CPU,
Chassis, and chip fan speeds in rotations per minute (RPM). If any of the fans is
not connected to the motherboard, the field shows 0. These items are not user-
configurable.
Vcore.Voltage,.3.3V.Voltage,.5V.Voltage,.12V.Voltage.
The onboard hardware monitor automatically detects the voltage output through
the onboard voltage regulators. Configuration options: [xxx] [Ignored]
Select Menu
Item Specific Help
Press [Enter] to
enable or disable
Hardware Monitor
Q-Fan Controller [ Disabled ]
CPU Target Temperature [60 º C/140 º F]
System Target Temperature [60 º C/140 º F]
CPU Temperature 41ºC/105ºF
System Temperature 31ºC/87ºF
CPU Fan Speed 3245 RPM
Chassis Fan Speed 0 RPM
Power Fan Speed 0 RPM
Vcore [1.35V]
Vcc 12V [12.12V]
Vcc 3.3V [3.29V]
Vxx 5.0V [5.13V]
CPU Fan Type [Auto]
CPU Fan Speed warning [800 RPM]
Phoenix-Award BIOS CMOS Setup Utility
Power
F1:Help ↑↓ : Select Item -/+: Change Value F5: Setup Defaults
ESC: Exit →←: Select Menu Enter: Select SubMenu