Asus P5K3 Premium/WiFi-AP - Manual (Page 143)

ASUS P5K3 Premium 5-39
5.4.4 JMicron ® RAID Configuration
The JMicron ® Serial ATA controller allows you to configure RAID 0 and RAID 1 sets
on the external Serial ATA hard disk drives.
Before creating a RAID set
Prepare the following items:
1. Two SATA HDDs, preferably with the same model and capacity.
2. A write-enabled floppy disk for Windows
® XP or a floppy disk/USB device for
Windows ® Vista.
3. Microsoft ® Windows ® OS installation disk (Windows ® XP/Vista)
4. Motherboard support DVD with JMB363 driver
Complete the following steps before you create a RAID set:
1. Install the two external Serial ATA hard disk drives on your system.
2. Set the
Controller Mode item in the BIOS to [RAID]. See section 4.4.5
Onboard Devices Configuration for details.
3. Enter the JMB363 RAID BIOS utility to set up your RAID configuration.
4. Create a JMB363 RAID driver disk for Windows
® OS installation. See section
5.5 Creating a RAID driver disk for details.
5. Install the JMB363 driver after the Windows ® OS had been installed.
Always install the JMB363 driver before creating RAID sets.
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
v02.58 (C)Copyright 1985-2007, American Megatrends, Inc.
BIOS SETUP UTILITY
Advanced
Onboard Device Configuration
High Definition Audio [Enabled]
Front Panel Type [HD Audio]
J-Micron eSATA/PATA Controller [Enabled]
Controller Mode [RAID]
Realtek GigaBit LAN [Enabled]
LAN Boot ROM [Disabled]
Marvell GigaBit LAN [Enabled]
LAN Boot ROM [Disabled]
Realtek Wireless LAN [Enabled]
Agere Firewire 1394 [Enabled]
Serial Port1 Address [3F8/IRQ4]
Enable or Disable
High Definition Audio
Controller