Asus Terminator C3 - Manual (Page 55)

A S U S T e r m i n a t o r T 1 C 3 b a r e b o n e s y s t e m A S U S T e r m i n a t o r T 1 C 3 b a r e b o n e s y s t e m A S U S T e r m i n a t o r T 1 C 3 b a r e b o n e s y s t e m A S U S T e r m i n a t o r T 1 C 3 b a r e b o n e s y s t e m A S U S T e r m i n a t o r T 1 C 3 b a r e b o n e s y s t e m 4 - 5 4 - 5 4 - 5 4 - 5 4 - 5
4.4 Connectors
This section describes and illustrates the connectors on the motherboard.
See page 1-4 for the description of rear panel connectors.
1 . 1 . 1 . 1 . 1 . I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ I D E , S E C _ I D E ) I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ I D E , S E C _ I D E ) I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ I D E , S E C _ I D E ) I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ I D E , S E C _ I D E ) I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ I D E , S E C _ I D E )
These connectors are for Ultra DMA 133/100/66 signal cables. The
Ultra DMA 133/100/66 signal cable has three connectors: a blue
connector for the primary IDE connector on the motherboard, a black
connector for an Ultra DMA 133/100/66 IDE slave device (optical
drive/hard disk drive), and a gray connector for an Ultra DMA
133/100/66 IDE master device (hard disk drive). If you install two
hard disk drives, you must configure the second drive as a slave
device by setting its jumper accordingly. Refer to the hard disk
documentation for the jumper settings.
• Pin 20 on the IDE connector is removed to match the covered hole
on the Ultra DMA cable connector. This prevents incorrect insertion
when you connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE
devices.
C3V ®
C3V IDE connectors
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
SEC_IDE
PIN 1
PRI_IDE