Asus VW225TL - Manual (Page 14)

2-2 Chapter 2: Setup
2.3 Detaching the arm/base (for VESA
wall mount)
The detachable arm / base of the VW195xL/VW202xL/VW225xL Series LCD
monitor is specially designed for VESA wall mount.
To detach the arm/base
1. Lower the monitor to its lowest height, and then insert the monitor height
adjustment lock (Figure 1).
2. Have the front of the monitor face down on a table.
3. Remove the rubbers in the four screw holes (Figure 2).
4. Use a screwdriver to remove the two screws on the arm (Figure 2), then slide
out the arm/base to detach it from the monitor (Figure 3).
2.2 Adjusting the monitor angles
• For optimal viewing, we recommend that you look at the full face of the monitor,
then adjust the monitor to the angle that is most comfortable for you.
• Hold the base to prevent the monitor from falling when you change its angle.
• You can tilt the monitor’s from -3º to 20º, swivel from left-to-right for 45º, and lift
the monitor’s height for about 70mm.
-3º~20º
70mm
45º 45º
0º