Asus GigaX2008EX - Manual (Page 50)

40
GigaX2008EX L2 Managed Switch User Manual
CLI command: l2 trunk remove <trunk id> <port list>
[Reload]
Restores the previous saved settings of trunk from configuration file.
CLI command: l2 trunk retrieve
[Mirror Mode] [Enable/Disable]
[Monitor Port] [port number]
Displays the mirroring settings of the switch.
CLI command: l2 mirror create <monitor port no> <enable/disable>
CLI command: l2 mirror ingress <port list>
CLI command: l2 mirror egress <port list>
CLI command: l2 mirror remove <ingress/egress> <port list>
[Reload]
Restores the previous saved settings from configuration file.
CLI command: l2 mirror retrieve
[Limit Rate]
User can limit the broadcast, multicast, and flooding (due to destination lookup
failed) traffic rate by turning the traffic control on.
CLI command: l2 rate set <enable/disable> [<mode (1:broadcast only, 2:
broadcast and multicast, 3:broadcast, multicast and unknown unicast )>
<limit rate (70~250000 Kbps/sec)>]
[Reload]
Restores the previous saved settings from configuration file.
CLI command: l2 rate retrieve
[Aging Time]
User can set the ARL (Address Resolution Logic) entries aging time by setting
the aging time value.
CLI command: l2 arl age [aging time value]
[Query by Port]
ARL entries existed in ARL table can be queried according to port number.
CLI command: l2 arl port <port number>