Asus P8H61-M LX2 - Manual (Page 49)

Chapter 2: BIOS information 2-17
CPU C1E [Enabled]
[Enabled] Enables the C1E support function. This item should be enabled in order to
enable the Enhanced Halt State.
[Disabled] Disables this function.
CPU C3 Report [Enabled]
Allows you to disable or enable the CPU C3 report to the operating system. Configuration
options: [Disabled] [Enabled]
CPU C6 Report [Enabled]
Allows you to disable or enable the CPU C6 report to the operating system. Configuration
options: [Enabled] [Disabled]
2.5.2 System Agent Configuration
Initiate Graphic Adapter [PEG/PCI]
Allows you to decide which graphics controller to use as the primary boot device.
Configuration options: [iGPU] [PCI/iGPU] [PCI/PEG] [PEG/iGPU] [PEG/PCI]
iGPU Memory [64M]
Allows you to set the iGPU memory size. Configuration options: [32M] [64M] [96M] [128M]
Render Standby [Enabled]
Allows you to enable or disable Render Standby by internal graphics devices. Configuration
options: [Disabled] [Enabled]
iGPU Multi-Monitor [Disabled]
Allows you to enable or disable the internal graphics device’s multi-monitor support for
add-on VGA devices. And the memory size for internal graphics device will keep 64MB.
Configuration options: [Disabled] [Enabled]
2.5.3 PCH Configuration
High Precision Timer [Enabled]
Allows you to enable or disable the High Precision Event Timer.
Configuration options: [Enabled] [Disabled]
2.5.4 SATA Configuration
While entering Setup, the BIOS automatically detects the presence of SATA devices. The
SATA Port items show Not Present if no SATA device is installed to the corresponding SATA
port.