Asus P8P67 EVO - Manual (Page 41)

ASUS P8P67 EVO 2-23
Chapter 2
3. Marvell ® Serial ATA 6.0 Gb/s connectors (7-pin SATA6G_E1/E2 [navy blue])
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0
Gb/s signal cables.
• The SATA6G_E1/E2 (navy blue) connectors are for data drives only. ATAPI device is
not supported.
• You must install Windows ® XP Service Pack 3 or later versions before using Serial ATA
hard disk drives.
• When using NCQ, set the Marvell Storage Controller item in the BIOS to [AHCI
Mode]. Refer to section 3.5.6 Onboard Devices Configuration for details.