Asus V2Je - Manual (Page 55)


Using the Notebook PC
4
Telephone Wall
Jack
Telephone cables
with RJ-11 connectors
Telephone
connection is
optional
Telephone connector
is the smaller of the two�
NOTE: The built-in modem and network cannot be installed later as an upgrade. After
purchase, modem and/or network can be installed as an expansion card.
CAUTION: For electrical safety concerns, only use telephone cables rated 26AWG or
higher. (see Glossary for more information)
NOTE: When you are connected to an online service, do not place the Notebook PC
in suspend (or sleep mode) or else you will disconnect the modem connection.
Connections
Modem Connection
The telephone wire used to connect the Notebook PC’s internal modem should
have either two or four wires (only two wires (telephone line #1) is used by the
modem) and should have an RJ-11 connector on both ends. Connect one end to the
modem port and the other end to an analog telephone wall socket (the ones found
in residential buildings). Once the driver is setup, the modem is ready to use.
Example of the Notebook PC connected to a telephone jack for use with the built-in modem: