Asus E45M1-I DELUXE - Manual (Page 23)

1-13 Chapter 1: Product introduction
4. Serial ATA 6.0Gb/s connectors (7-pin SATA6G_1~5)
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0
Gb/s signal cables.
• These connectors are set to [IDE Mode] by default. In IDE mode, you can connect Serial
ATA boot/data hard disk drives to these connectors.
• When using hot-plug and NCQ, set the OnChip SATA Type item in the BIOS to [AHCI
Mode]. See section 2.5.2 SATA Configuration for details.
5. Front panel audio connector (10-1 pin AAFP)
This connector is for a chassis-mounted front panel audio I/O module that supports
either HD Audio or legacy AC`97 audio standard. Connect one end of the front panel
audio I/O module cable to this connector.
• We recommend that you connect a high-definition front panel audio module to this
connector to avail of the motherboard’s high-definition audio capability.
• If you want to connect a high-definition front panel audio module to this connector, set
the Front Panel Type item in the BIOS setup to [HD]. If you want to connect an AC'97
front panel audio module to this connector, set the item to [AC97]. By default, this
connector is set to [HD]. See section 2.5.5 Onboard Devices Configuration for details.
E35M1-I DELUXE
SATA6G_2
GN
D
RSATA_RXN2 RSATA_RXP2 GN
D
RSATA_TXN2 RSATA_TXP2 GN
D
SATA6G_1
GN
D
RSATA_RXN1 RSATA_RXP1 GN
D
RSATA_TXN1 RSATA_TXP1 GN
D
SATA6G_4
GN
D
RSATA_RXN
4
RSATA_RXP
4
GN
D
RSATA_TXN
4
RSATA_TXP
4
GN
D
SATA6G_3
GN
D
RSATA_RXN
3
RSATA_RXP
3
GN
D
RSATA_TXN
3
RSATA_TXP
3
GN
D
SATA6G_5
GN
D
RSATA_RXN5 RSATA_RXP5 GN
D
RSATA_TXN5 RSATA_TXP5 GN
D
E45M1-I DELUXE SATA 6.0Gb/s connectors
E35M1-I DELUXE
E45M1-I DELUXE Front panel audio connector
AAFP
PIN 1
GND
PRESENCE#
SENSE1_RETUR
SENSE2_RETUR
PORT1 L
PORT1 R
PORT2 R
SENSE_SEND
PORT2 L
HD-audio-compliant
pin definition
PIN 1
AGND
NC
NC
NC
MIC2
MICPWR
Line out_R
NC
Line out_L
Legacy AC’97
compliant definition