Asus MES - Manual (Page 15)

ASUS MES User’s Manual 15
3. HARDWARE SETUP
3.2 Layout Contents
Motherboard Settings
1) KB WAKEUP p.18 Keyboard Wake Up Setting (Enable/Disable)
2) DSW1-6, DSW1-7 p.19 Voltage I/O Setting (+0.1V/Normal)
3) DSW1-8 p.19 CPU Core Voltage (Vcore) Setting (+0.1V/Normal)
4) DSW2-5 p.20 Onboard VGA Setting (Enable/Disable)
5) DSW2-6 p.20 VGA Frame Buffer Setting (UMA/Non-UMA)
6) DSW2-7 p.21 LCD Setting (Enable/Disable)
7) DSW2-8 p.21 Onboard Audio Setting (Enable/Disable)
8) DSW1-1, 2, 3, 4 p.22 CPU External Frequency Setting
9) DSW1-5 p.22 Memory Transfer Mode Setting (SYNC/ASYNC)
10) DSW2-1, 2, 3, 4 p.23 CPU Core:External Frequency Multiple Setting
Expansion Slots
1) DIMM1, DIMM2, DIMM3 p.24 168-Pin DIMM Memory Support
2) Socket 370 p.26 Central Processing Unit (CPU) Socket
3) SLOT1, SLOT2 p.27 16-bit ISA Bus Expansion Slots *
4) PCI1, PCI2, PCI3, PCI4, PCI5 p.27 32-bit PCI Bus Expansion Slots
Connectors
1) PS2KBMS p.29 PS/2 Mouse Connector (6-pin female)
2) PS2KBMS p.29 PS/2 Keyboard Connector (6-pin female)
3) USB p.30 Universal Serial BUS Ports 1 & 2 (Two 4-pin female)
4) PRINTER p.30 Parallel Port Connector (25-pin female)
5) COM1 p.30 Serial Port COM1 Connector (9-pin male)
6) VGA p.31 Monitor (VGA) Output Connector (15-pin female)
7) GAME_AUDIO p.31 Joystick/Midi Connector (15-pin female) (optional)
8) GAME_AUDIO p.31 Audio Port Connectors (Three 1/8” female) (optional)
9) PRIMARY/SECONDARY IDE p.32 Primary/Secondary IDE Connectors (Two 40-1pins)
10) FLOPPY p.32 Floppy Disk Drive Connector (34-1pins)
11) WOL_CON p.33 Wake-On-LAN Connector (3 pins)
12) WOR p.33 Wake-On-Ring Connector (2 pins)
13) IDE p.34 IDE Activity LED (2 pins)
14) CHA_, CPU_, PWR_FAN p.34 Chassis, CPU, Power Supply Fan Connectors (Three 3-pin)
15) AUX, MODEM, CD2, CD1 p.35 Internal Audio Connectors (Four 4-pin)
16) IR
p.35 IrDA-Compliant Infrared Module Connector (5 pins)
17) SCART p.36 TV Out Header (12-1 pins)
18) LCDHD p.36 LCD Header (20 pins)
19) SMB p.37 SMBus Connector (5-1 pins)
20) COM2 p.37 Serial Port COM2 Header (10-1 pins)
Layout Contents
3. H/W SETUP
(Cont’d on next page)
* The integrated hardware monitor uses the address 290H-297H so legacy ISA cards must not
use this address; otherwise, conflicts will occur.