Asus K8V-VM Ultra - Manual (Page 49)

ASUS K8V-VM Ultra Motherboard 2-13
DMA Mode [Auto]
Selects the DMA mode. Configuration options: [Auto] [SWDMA0] [SWDMA1]
[SWDMA2] [MWDMA0] [MWDMA1] [MWDMA2] [UDMA0] [UDMA1] [UDMA2]
[UDMA3] [UDMA4] [UDMA5]
SMART Monitoring [Auto]
Sets the Smart Monitoring, Analysis, and Reporting Technology.
Configuration options: [Auto] [Disabled] [Enabled]
32Bit Data Transfer [Disabled]
Enables or disables 32-bit data transfer.
Configuration options: [Disabled] [Enabled]
2.3.5 IDE Configuration
The items in this menu allow you to set or change the configurations for
the IDE devices installed in the system. Select an item then press <Enter>
if you want to configure the item.
Parallel ATA IDE Controller [Both]
Hard Disk Write Protect [Disabled]
IDE Detect Time Out (Sec) [35]
ATA(PI) 80Pin Cable Detection [Host]
Parallel ATA IDE Controller [Both]
Allows you to select the Parallel ATA IDE controller.
Configuration options: [Disabled] [Primary] [Secondary] [Both]
Hard Disk Write Protect [Disabled]
Allows you to enable to disable the hard disk write protection. This will be effective
only if device is accessed through BIOS. Configuration options: [Disabled] [Enabled]
IDE Detect Time Out (Sec) [35]
Allows you to select the time out value for detecting ATA or ATAPI device(s).
Configuration options: [0] [5] [10] [15] [20] [25] [30] [35]
ATA(PI) 80Pin Cable Detection [Host]
Allows you to select the mechanism for detecting 80Pin ATA(PI) cable.
Configuration options: [Host & Device] [Host] [Device]