4 keeping your shaver in top shape – Braun 3775 InterFace Excel User Manual

Page 8

Advertising
background image

8

3.2 Shaving with the cord

If the batteries are discharged, you may also shave with the shaver connected
to the mains (100–240 V ~). (If the shaver should not run immediately, charge
it with the switch position «off» for approx. 1 minute.)

4 Keeping your shaver in top shape

4.1 Cleaning

•

After shaving, switch the shaver off. Press the release buttons, take off the
shaver foil (d) and gently tap it out on a flat surface (e).

•

Then thoroughly clean the cutter block with the brush (f). About every four
weeks, clean the cutter block with Braun cleaning agents (g).

•

Do not clean the shaver foil with the brush.

•

If you have a very dry skin and you notice a reduced operation time of the
shaver, you should put a drop of light machine oil onto the InterFace trimmer
and shaver foil (g).

4.2 Replacing the shaving parts

•

To maintain 100% shaving performance, replace your foil and cutter block
every 18 months or when worn. Change both parts at the same time for a
closer shave with less skin irritation.
(Shaver foil and cutter block: part no. 3000)

•

Press the release buttons, take off the shaver foil. Replace the new shaver foil
in the right direction until it locks in place.

•

To remove the cutter block, lift it off (g).

•

To replace the cutter block, snap onto the holding studs.

4.3 Preserving the rechargeable batteries

•

In order to optimise the capacity and life of the batteries, the shaver should be
fully discharged through regular use every 6 months approximately. Then
recharge to full capacity again. This reconditions the rechargeable batteries.

•

Do not expose the shaver to temperatures of more than 50 °C for long periods
of time.

Tips for the perfect shave

• We recommend that you shave before washing, as the skin tends to be

slightly swollen after washing.

• Hold the shaver at right angles (90°) to the skin.
• Stretch your skin and shave against the direction of beard growth.
• To maintain 100% shaving performance, replace your foil and cutter block

every 18 months or when worn.

5635301_IF3775/70_S4_50 Seite 8 Montag, 17. Oktober 2005 12:23 12

Advertising