Asus A8N-VM CSM/NBP - Manual (Page 66)

2 - 2 6 2 - 2 6 2 - 2 6 2 - 2 6 2 - 2 6 C h a p t e r 2 : B I O S s e t u p C h a p t e r 2 : B I O S s e t u p C h a p t e r 2 : B I O S s e t u p C h a p t e r 2 : B I O S s e t u p C h a p t e r 2 : B I O S s e t u p
2.5 Power menu
The Power menu items allow you to change the settings for the Advanced
Power Management (APM). Select an item then press <Enter> to display
the configuration options.
2.5.1 2.5.1 2.5.1 2.5.1 2.5.1 ACPI Aware O/S [Yes] ACPI Aware O/S [Yes] ACPI Aware O/S [Yes] ACPI Aware O/S [Yes] ACPI Aware O/S [Yes]
Allows you to Enable/Disable ACPI support for Operating System. If OS
supports ACPI please set to [Enable], if OS does not supports ACPI please
set to [Disable]. Configuration options: [No] [Yes]
2.5.2 2.5.2 2.5.2 2.5.2 2.5.2 Suspend Mode [S1 (POS) only] Suspend Mode [S1 (POS) only] Suspend Mode [S1 (POS) only] Suspend Mode [S1 (POS) only] Suspend Mode [S1 (POS) only]
Allows you to select the Advanced Configuration and Power Interface
(ACPI) state to be used for system suspend.
Configuration options: [S1 (POS) Only] [S3 Only] [Auto]
2.5.3 2.5.3 2.5.3 2.5.3 2.5.3 ACPI 2.0 Support [Enabled] ACPI 2.0 Support [Enabled] ACPI 2.0 Support [Enabled] ACPI 2.0 Support [Enabled] ACPI 2.0 Support [Enabled]
Specifies the Advanced Configuration and Power Interface (ACPI) version
supported. Configuration options: [Disabled] [Enabled]
v02.58 (C)Copyright 1985-2004, American Megatrends, Inc.
BIOS SETUP UTILITY
Main Advanced Power Boot Exit
ACPI Aware O/S [Yes]
Suspend Mode [S1 (POS) only]
ACPI 2.0 Support [Enabled]
ACPI APIC Support [Enabled]
APM Configuration
Hardware Monitor
Select the ACPI state
used for System
Suspend.
The following items will shown when TCG/TPM device support set to
[Yes].
Soft. Physical [No] Soft. Physical [No] Soft. Physical [No] Soft. Physical [No] Soft. Physical [No]
Allows you to enable or disable software indication of physical presence.
Configuration options: [No] [Yes]
TPM status reset [Don’t change] TPM status reset [Don’t change] TPM status reset [Don’t change] TPM status reset [Don’t change] TPM status reset [Don’t change]
Allows you to enable or disable TPM device. Configuration options: [Don’t
change] [Set] [Clear].
Owner status [Don’t change] Owner status [Don’t change] Owner status [Don’t change] Owner status [Don’t change] Owner status [Don’t change]
Allows you to enable/disable and install/clear TPM owner. Configuration
options: [Don’t change] [Clear].