Asus P2B-DS - Manual (Page 15)

ASUS P2B-D/P2B-DS User’s Manual 15
NOTES: Overclocking your processor is not recommended. It may result in a slower
speed. Voltage Regulator Output Selection (VID) is not needed for the Pentium III/
II processor because it sends a VID signal directly to the onboard power controller.
5. Chassis Intrusion Sensor Setting (JP18) (optional/reserved)
This allows you to disable or enable the chassis intrusion sensor. Set to Enable if
you want to use this function to monitor intrusion into your computer, for ex-
ample, when the drive bay doors are opened. The default is set to Disable.
P2B-D/DS Chassis Intrusion Sensor Setting
1
1
R
Disable
(Default)
Enable
JP18 JP18
III. INST
ALLA
TION
Motherboard Settings
Set the jumpers by the Internal speed of your processor as follows:
(Bus Freq.) (Freq. Mult.)
Intel CPU Model Freq. Mult. Bus F. FS2 FS1 FS0 BF3 BF2 BF1 BF0
Pentium III 600MHz 6.0x 100MHz [1-2] [1-2] [1-2] [1-2] [2-3] [2-3] [2-3]
Pentium III 550MHz 5.5x 100MHz [1-2] [1-2] [1-2] [2-3] [1-2] [1-2] [1-2]
Pentium III 500MHz 5.0x 100MHz [1-2] [1-2] [1-2] [2-3] [1-2] [1-2] [2-3]
Pentium III/II 450MHz 4.5x 100MHz [1-2] [1-2] [1-2] [2-3] [1-2] [2-3] [1-2]
Pentium II 400MHz 4.0x 100MHz [1-2] [1-2] [1-2] [2-3] [1-2] [2-3] [2-3]
Pentium II 350MHz 3.5x 100MHz [1-2] [1-2] [1-2] [2-3] [2-3] [1-2] [1-2]
Pentium II 333MHz 5.0x 66MHz [2-3] [1-2] [1-2] [2-3] [1-2] [1-2] [2-3]
Pentium II 300MHz 4.5x 66MHz [2-3] [1-2] [1-2] [2-3] [1-2] [2-3] [1-2]
Pentium II 266MHz 4.0x 66MHz [2-3] [1-2] [1-2] [2-3] [1-2] [2-3] [2-3]
Pentium II 233MHz 3.5x 66MHz [2-3] [1-2] [1-2] [2-3] [2-3] [1-2] [1-2]
For updated processor settings, please visit ASUS’ web site (see ASUS CONTACT INFORMATION).
III. INSTALLATION