Asus P5QL SE - Manual (Page 31)

ASUS P5QL SE 1-21
3.. IDE.connector.(40-1.pin.PRI_EIDE)
The onboard IDE connector is for an Ultra DMA 133/100/66 signal cable. There are
three connectors on an Ultra DMA 133/100/66 signal cable: blue, black, and gray.
Connect the blue connector to the motherboard’s IDE connector, then select one of the
following modes to configure your device.
Drive.jumper.setting Mode.of.device(s) Cable.connector
Single device Cable-Select or Master - Black
Two devices
Cable-Select
Master Black
Slave Gray
Master Master
Black or gray
Slave Slave
• Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA
cable connector. This prevents incorrect insertion when you connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.
PRI_IDE
NOTE:Orient the red markings
on the IDE ribbon cable to PIN 1.
PIN1 P5QL SE
P5QL SE IDE connector
If any device jumper is set as
“Cable-Select,” ensure that all other
device jumpers have the same
setting.
4.. Optical.drive.audio.connector.(4-pin.CD)
These connectors allow you to receive stereo audio input from sound sources such as
a CD-ROM, TV tuner, or MPEG card.
CD
Right
Audio Channe
l
GN
D
GN
D
Left
Audio Channe
l
P5QL SE
P5QL SE Internal audio connector