Asus M4A88T-M/USB3 - Manual (Page 28)

1.7.3 Installing a DIMM
Unplug the power supply before adding or removing DIMMs or other system components.
Failure to do so can cause severe damage to both the motherboard and the components.
To install a DIMM:
1.
Press the retaining clips outward to
unlock a DIMM socket.
2. Align a DIMM on the socket such that
the notch on the DIMM matches the
DIMM slot key on the socket.
Unlocked retaining clip
1
DIMM notch
2
1
A DIMM is keyed with a notch so that it fits in only one direction. DO NOT force a DIMM into
a socket in the wrong direction to avoid damaging the DIMM.
3. Hold the DIMM by both of its ends, then
insert the DIMM vertically into the socket.
Apply force to both ends of the DIMM
simultaneously until the retaining clip
snaps back into place, and the DIMM
cannot be pushed in any further to ensure
proper sitting of the DIMM.
Locked Retaining Clip
3
1.7.4 Removing a DIMM
To remove a DIMM:
1.
Simultaneously press the retaining clips
outward to unlock the DIMM.
2. Remove the DIMM from the socket.
Support the DIMM lightly with
your fingers when pressing the
retaining clips. The DIMM might
get damaged when it flips out with
extra force.
1
1
2
DIMM slot key
Always insert the DIMM into the socket VERTICALLY to prevent DIMM notch damage.
Chapter 1: Product introduction 1-16