Asus M2N-X PLUS - Manual (Page 57)

ASUS M2N-X PLUS 2-15
2.3.4 IDE Configuration
The items in this menu allow you to set or change the configurations for the IDE
devices installed in the system. Select an item then press <Enter> if you wish to
configure the item.
IDE Configuration
Onboard IDE Controller [Enabled]
Serial-ATA Devices [Device 0/1]
nVidia RAID Function [Disabled]
Onboard IDE Controller [Enabled]
Allows you to enable or disable the onboard IDE controller.
Configuration options: [Disabled] [Enabled]
Serial-ATA Devices [Device 0/1]
Allows you to enable or disable the serial-ATA devices.
Configuration options: [Disabled] [Device 0] [Device 0/1]
nVidia RAID Function [Disabled]
Allows you to enable or disable the NVIDIA RAID function.
Configuration options: [Disabled] [Enabled]
2.3.5 Primary IDE Master/Slave
While entering Setup, the BIOS automatically detects the presence of IDE devices.
There is a separate sub-menu for each IDE device. Select a device item then
press <Enter> to display the IDE device information.
Primary IDE Master
Device : Hard Disk
Vendor : ST320413A
Size : 20.0GB
LBA Mode : Supported
Block Mode : 16 Sectors
PIO Mode : Supported
Async DMA : MultiWord DMA-2
Ultra DMA : Ultra DMA-5
SMART Monitoring: Supported
Type [Auto]
LBA/Large Mode [Auto]
Block(Multi-Sector Transfer) M [Auto]
PIO Mode [Auto]
DMA Mode [Auto]
SMART Monitoring [Auto]
32Bit Data Transfer [Enabled]
Exit
Disabled: disables
the integrated IDE
Controller.
Enabled: enable
the integrated IDE
Controller.
Select the type
of device connected
to the system.