Asus M2N 1394 - Manual (Page 55)

ASUS MN 1394 -15
2.3.4 IDE Configuration
The items in this menu allow you to set or change the configurations for the IDE
devices installed in the system. Select an item then press <Enter> if you wish to
configure the item.
IDE Configuration
Onboard IDE Controller [Enabled]
OnChip S-ATA Controller [Enabled]
SATA Mode Select [IDE Mode]
Onboard IDE Controller [Enabled]
Allows you to enable or disable the onboard IDE controller.
Configuration options: [Enabled] [Disabled]
OnChip S-ATA Controller [Enabled]
Allows you to enable or disable the OnChip SATA.
Configuration options: [Disabled] [Enabled]
SATA Mode Select [IDE Mode]
Configuration options: [IDE Mode] [RAID Mode] [AHCI Mode]
2.3.5 Primary IDE Master/Slave
While entering Setup, the BIOS automatically detects the presence of IDE devices.
There is a separate sub-menu for each IDE device. Select a device item then
press <Enter> to display the IDE device information.
Third IDE Master
Device : Not Detected
Type
[Auto]
LBA/Large Mode [Auto]
Block(Multi-sector Transfer) M [Auto]
PIO Mode [Auto]
DMA Mode [Auto]
SMART Monitoring [Auto]
32Bit Data Transfer [Enabled]