Asus M4A78T-E - Manual (Page 56)

2-36 Chapter 2: Hardware information
Chapter 2
1. Connect the front panel cables to the ASUS
Q-Connector.
Refer to the labels on the Q-Connector to know the
detailed pin definitions, and then match them to
their respective front panel cable labels.
The labels on the front panel cables
may vary depending on the chassis
model.
2. Install the ASUS Q-Connector to the system panel
connector, making sure the orientation matches the
labels on the motherboard.
3. The front panel functions are now enabled. The
figure shows the Q-Connector is properly installed
on the motherboard.
IDE_LED
POWER SW
RESET SW
IDE_LED-
IDE_LED+
PWR
Reset
Ground
Ground
14. ASUS Q-Connector (system panel)
Use the ASUS Q-Connector to connect/disconnect the chassis front panel cables.
To install the ASUS Q-Connector