Asus P8Z77-V PREMIUM - Manual (Page 169)

ASUS P8Z77-V PREMIUM 5-9
Chapter 5
4. Use the up or down arrow key to move the selection bar and press <Enter> to
configure further RAID settings.
RAID Level: Select a RAID Level. Configuration options: [RAID 0] [RAID 1]
Stripe Size: Specifies the size of single data block on the virtual disk. In general, a
larger stripe size is recommended for applications requiring large data transfers such
as audio, video, and graphics. A smaller stripe size is better for applications with
content in much smaller size, such as e-mails and documents.
Configuration options: [32K] [64K]
Gigabyte Rounding: In the event of a single physical disk failure in a RAID 1 virtual
disk, Gigabyte Rounding allows the replacement physical disk to be of a size slightly
smaller than the existing physical disk. The capacity of the rebuilt virtual disk equals
to the size of the smaller physical disk included in the RAID 1 array. The configuration
options represent the tolerance value of drive capacity difference.
Configuration options: [None] [1G] [10G]
Name: Enter a name with 1–10 letters (no special characters) for the RAID array.
5. Move the selection bar to Next and press <Enter>. The following warning message
appears:
Do you want to create this virtual disk ?
Y es N o
Create Virtual Disk
Press <Y> to create the RAID array, or press <N> to cancel. The new RAID array
appears under Virtual Disks, as shown in the image below.
Marvell BIOS Setup (c) 2009 Marvell Technology Group Ltd.
Help
Marvell RAID on chip controller.
ENTER: Operation F10: Exit/Save ESC: Return
HBA 0: Marvell 0
├ Virtual Disks
│ └ VD 0: New_VD
│ ├ PD 0: ST3160812AS
│ └ PD 8: ST3160812AS
└ Free Physical Disks
Vendor ID :
Device ID :
Revision ID :
BIOS Version :
Firmware Version:
PCIe Speed Rate :
Configure SATA as:
▶ ▶
Topology Information
1B4B
9130
B1
1.0.0.1028
2.2.0.1105
5.0Gbps
AHCI Mode