Asus T2-PH1 - Manual (Page 69)

4 - 1 1 4 - 1 1 4 - 1 1 4 - 1 1 4 - 1 1 A S U S T 2 - P H 1 A S U S T 2 - P H 1 A S U S T 2 - P H 1 A S U S T 2 - P H 1 A S U S T 2 - P H 1
1 1 . 1 1 . 1 1 . 1 1 . 1 1 . I D E c o n n e c t o r ( 4 0 - 1 p i n P R I _ I D E ) I D E c o n n e c t o r ( 4 0 - 1 p i n P R I _ I D E ) I D E c o n n e c t o r ( 4 0 - 1 p i n P R I _ I D E ) I D E c o n n e c t o r ( 4 0 - 1 p i n P R I _ I D E ) I D E c o n n e c t o r ( 4 0 - 1 p i n P R I _ I D E )
This connector is for an Ultra DMA 100/66 signal cable. The Ultra DMA
100/66 signal cable has three connectors: a blue connector for the
primary IDE connector on the motherboard, a black connector for an
Ultra DMA 100/66 IDE slave device (optical drive/hard disk drive), and
a gray connector for an Ultra DMA 100/66 IDE master device (hard disk
drive). Refer to the hard disk documentation for the jumper settings.
• Pin 20 on the IDE connector is removed to match the covered hole
on the Ultra DMA cable connector. This prevents incorrect insertion
when you connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.
®
IDE connector
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
PIN 1
PRI_IDE