Asus Maximus III Extreme - Manual (Page 109)

ROG Maximus III Extreme 3-25
3.5.3 Onboard Device Configuration
HDA Controller [Enabled]
[Enabled] Enables the High Definition Audio Controller.
[Disabled] Disables the controller.
Front Panel Type [HD Audio]
[AC97]
Set the front panel audio connector (AAFP) mode to legacy AC’97
[HD Audio] Set the front panel audio connector (AAFP) mode to high-
definition audio.
Realtek LAN [Enabled]
[Enabled] Enables Realtek LAN Controller.
[Disabled] Disables Realtek LAN Controller.
LAN Boot ROM [Disabled]
This item appears only when you enable the previous item(s).
[Disabled] Disables Realtek LAN Boot ROM.
[Enabled] Enables Realtek LAN Boot ROM.
Onboard 1394 Controller [Enabled]
[Enabled] Enables the onboard 1394 Controller.
[Disabled] Disables the controller.
J-Micron Controller [IDE Mode]
[Disabled] Disables the J-Micron controller.
[IDE Mode] Set to [IDE Mode] when you want to use the Serial ATA hard disk
drives as Parallel ATA physical storage devices.
[AHCI Mode] Set to [AHCI] when you want the SATA hard disk drives to use the
AHCI (Advabced Host Controller Interface). The AHCI allows the
onboard storage driver to enable advanced Serial ATA features that
increases storage performance on random workloads by allowing
the drive to internally optimize the order of commands.
BIOS SETUP UTILITY
Advanced
Onboard Device Configuration
Onboard Devices [Standard]
HDA Controller [Enabled]
Front Panel Type [HD Audio]
Realtek LAN [Enabled]
LAN Boot ROM [Disabled]
Onboard 1394 Controller [Enabled]
J-Micron Controller [IDE Mode]
Marvell 9123 Controller [IDE Mode]
Marvell 9123 Boot ROM [Auto]
Onboard USB 3.0 Controller [Enabled]
Get your best
overclocking record!
“Onboard Device” is
to disable all the
unnecessary devices
when you want to reach
your best overclocking
record. But it will
keep 1 lan port alive
to submit your score.