Canon MultiPASS 10 - Manual (Page 13)

Canon MultiPASS 10 QRG ENGLISH
13
LOADING PAPER
Running out of recording paper may cause memory reception. Load paper into the paper tray and press [STOP] to begin
printing the stored document(s).
1 Loading Paper
(7)
1 Remove the paper tray cover. 2 Fan a small stack of up to
100 sheets (up to 10 mm
thick). Tap the edge of the
stack on a flat surface to
even the stack. 3 Line up the right edge of the
stack of paper against the
right edge of the paper tray
and insert it halfway into the
paper tray.
4 Holding the stack of paper,
squeeze and slide the paper
guide until it touches the left
edge of the stack of paper.
Make sure the stack of paper
does not exceed the paper limit
mark on the right side of the
feeder.
A4
LT R
A4
LT R
5 Complete inserting the stack
of paper into the paper tray
until it stops.
Do not force the paper down
into the fax.
6 Replace the paper tray cover.
7 Press [STOP].
The numbers in parentheses indicate the page in the MultiPASS TM 10 INSTRUCTION BOOK on which you can find further details.
ቢͰĢĴ a a a a aaaaa a a a aaaaaaaaaaaa