Asus P5V-X SE - Manual (Page 41)

ASUS P5V-X SE 1-29
2. Primary/Secondary IDE connectors
(40-1 pin PRI_IDE [blue]; 40-1 pin SEC_IDE [black])
The onboard IDE connectors are for Ultra DMA 133/100/66 signal cables.
There are three connectors on each Ultra DMA 133/100/66 signal cable:
blue, black, and gray. Connect the blue connector to the motherboard’s IDE
connector, then select one of the following modes to configure your device(s).
• Pin 20 on the IDE connector is removed to match the covered hole on the
Ultra DMA cable connector. This prevents incorrect insertion when you
connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.
If any device jumper is set as “Cable-Select,” make sure all other device
jumpers have the same setting.
P5
V
-X SE
P5V-X SE IDE Connectors
PRI_IDE
NOTE: Orient the red markings
(usually zigzag) on the ID
ribbon cable to PIN 1.
SEC_IDE
PIN1
Drive jumper setting Mode of
device(s)
Cable connector
Single device Cable-Select or Master - Black
Two devices Cable-Select Master
Black
Slave Gray
Master Master Black or gray
Slave Slave