Asus Vintage-PH1 - Manual (Page 30)

2 - 1 2 2 - 1 2 2 - 1 2 2 - 1 2 2 - 1 2 C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n
2.5 Installing a DIMM
The system motherboard comes with two Double Data Rate (DDR) Dual
Inline Memory Module (DIMM) sockets.
The following figure illustrates the location of the sockets:
• Installing DDR DIMMS other than the recommended configurations
may cause memory sizing error or system boot failure. Use any of
the recommended configurations in the table on the next page.
• Install only i d e n t i c a l i d e n t i c a l i d e n t i c a l i d e n t i c a l i d e n t i c a l (the same type and size) DDR DIMM in
DIMM_A and DIMM_B.
• Always install DIMMs with the same CAS latency. For optimum
compatibility, we recommend that you obtain memory modules from
the same vendor.
• Due to chipset resource allocation, the system may detect less than
2 GB system memory when you installed two 1 GB DDR memory.
• This motherboard does not support memory modules made up of
128 Mb chips or double-sided x16 memory modules.
2.5.1 2.5.1 2.5.1 2.5.1 2.5.1 Memory configurations Memory configurations Memory configurations Memory configurations Memory configurations
You may install up to 2 GB system memory using 256 MB, 512 MB, and
1 GB DDR DIMMs.
®
184-Pin DDR DIMM Sockets
DIMM_A1 DIMM_A2 DIMM_B1 DIMM_B2