Asus P5E3 DELUXE/WiFi-AP - Manual (Page 166)

5-52 Chapter 5: Software support
5.4.4 JMicron ® RAID Configuration
The JMicron ® Serial ATA controller allows you to configure RAID 0, RAID 1 and
JBOD sets on the external Serial ATA hard disk drives.
Before creating a RAID set
Prepare the following items:
1. Two SATA HDDs, preferably with the same model and capacity.
2. A write-enabled floppy disk (Windows XP). A write-enabled floppy disk or a
USB flash disk drive (Windows Vista)
3. Microsoft ® Windows ® OS installation disk (Windows XP)
4. Motherboard support CD with JMB363 driver
Complete the following steps before you create a RAID set:
1. Install the two external Serial ATA hard disk drives on your system.
2. Set the
Controller Mode item in the BIOS to [RAID]. See section 4.5.3
Onboard Device Configuration for details.
3. Enter the JMB363 RAID BIOS utility to set up your RAID configuration.
4. Create a JMB363 RAID driver disk for Windows
® OS installation. See section
5.5 Creating a RAID driver disk for details.
5. Install the JMB363 driver after the Windows ® OS had been installed.
Always install the JMB363 driver before creating RAID sets.
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
v02.61 (C)Copyright 1985-2007, American Megatrends, Inc.
BIOS SETUP UTILITY
Advanced
Onboard Device Configuration
High Definition Audio [Enabled]
Front Panel Type [HD Audio]
J-Micron eSATA/PATA Controller [Enabled]
Controller Mode [IDE]
Realtek GigaBit LAN [Enabled]
LAN Boot ROM [Disabled]
Marvell GigaBit LAN [Enabled]
LAN Boot ROM [Disabled]
Onboard Wireless LAN [Enabled]
Agere Firewire 1394 [Enabled]
Serial Port1 Address [3F8/IRQ4]
Enable or Disable
High Definition Audio
Controller