Asus Striker II Extreme - Manual (Page 169)

ROG Striker II Extreme / Striker II NSE 5-43
5.4.4 JMicron ® RAID Configuration
The JMicron ® Serial ATA controller allows you to configure RAID 0, RAID 1 and
JBOD sets on the external Serial ATA hard disk drives.
Before creating a RAID set
Prepare the following items:
1. Two SATA HDDs, preferably with the same model and capacity.
2. A write-enabled floppy disk (Windows XP). A write-enabled floppy disk or a
USB flash disk drive (Windows �ista)
3. Microsoft ® Windows ® OS installation disk (Windows XP/Windows Vista)
4. Motherboard support DVD with JMB363 driver
Complete the following steps before you create a RAID set:
1. Install two external Serial ATA hard disk drives on your system.
2. Set the JMicron RAID controller item in the BIOS to [RAID]. See section
4.5.3 Onboard Device Configuration for details.
3. Enter the �MB363 RAID BIOS utility to set up your RAID configuration.
4. Create a JMB363 RAID driver disk for Windows
® OS installation. See section
5.5 Creating a RAID driver disk for details.
5. Install the JMB363 driver after the Windows ® OS had been installed.
Always install the JMB363 driver before creating RAID sets.
Select Menu
Item Specific Help
Press [Enter] to
setHD Audio function.
Phoenix-AwardBIOS CMOS Setup Utility
Advanced
F1:Help ↑↓ : Select Item -/+: Change Value F5: Setup Defaults
ESC: Exit →←: Select Menu Enter: Select SubMenu F10: Save and Exit
Onboard Device Configuration
HD Audio [Auto]
Front Panel Support Type [HD Audio]
Onboard 1st nVidia LAN [Enabled]
Onboard 2nd nVidia LAN [Enabled]
JMicron RAID controller [IDE]
Onboard LAN Boot ROM [Disabled]
Onboard 1394 [Enabled]