Air Suspension C-2130 REV 10 User Manual
Page 9
Advertising
9
REV 10
05/02/2014
C-2130
C-2130
ARNOTT COil spRiNg CONVERsiON kiT
FOR
1999-2005
AUDi AllROAD
10.
Using a paint MarKer, MarK tHe eccentric bolts alignMent at tHe KnUcKle anD reMove it being
sUre to tUrn tHe nUt on tHe bacKsiDe. (FigUre 30-9)
11.
aFter all Fasteners are reMoveD, tHe loWer control arM sHoUlD Hang Free.
FigUre 30-9
FigUre 40-1
REAR coIL stRUt INstALLAtIoN
1.
install tHe rear coil strUt Up FroM tHe bottoM, MaKing sUre tHe locating pins are Facing
oUtWarD. install tHe tWo (2) FactorY Upper MoUnting bolts anD tigHten. (FigUre 40-1)
2.
sWing tHe control arM Up to align tHe sHocK bUsHing to its MoUnting Hole.
secUre WitH tHe FactorY HarDWare.
Tighten all nuts and bolts to manufacturer's specifications during the installation process.
Advertising